Starlink Install, Speed Test, and Review

Installing SpaceX’s Starlink with the volcano roof mount. Running speed tests and comparing Starlink to Telus Smart Hub. Rural internet solution!

𝐃𝐫𝐢𝐩 𝐋𝐨𝐨𝐩: "a downward hanging loop in a line that runs to a building"
A very important step that was missed and pointed out in the comments is using a drip loop. I should have ran the line below the wall penetration, then back up before entering the wall. This will allow any water that might travel down the line to drip to the ground and not direct it towards the wall. See 7:34 for an example of a drip loop.

𝗔𝗺𝗮𝘇𝗼𝗻 𝗔𝗳𝗳𝗶𝗹𝗶𝗮𝘁𝗲 𝗟𝗶𝗻𝗸𝘀
Cover Plate Retro-fit
https://geni.us/A2538T
Cover Plate Box Required
https://geni.us/QHkq
1 ½” SS Exhaust Clamp
https://geni.us/DKFr
1 ½” SS Hose Clamp
https://geni.us/9F3V

𝐓𝐢𝐦𝐞 𝐒𝐭𝐚𝐦𝐩𝐬
0:00 Unboxing
0:26 Installation Plan
2:43 Install
9:22 Setup
10:15 Recap
11:24 Speed Tests
12:01 Starlink vs Telus

𝗦𝘂𝗽𝗽𝗼𝗿𝘁
Want to support my channel or give back? Help me improve on these DIY videos by making a financial contribution. All contributions no matter how small are greatly appreciated!
https://ko-fi.com/prosdiy
Thank you!

𝗖𝗼𝗻𝗻𝗲𝗰𝘁
More DIY videos! https://www.prosdiy.com
Facebook: https://www.facebook.com/prosdiy
Instagram: https://www.instagram.com/prosdiy
Subscribe: https://www.youtube.com/c/prosdiy
Amazon: https://www.amazon.com/shop/prosdiy

Disclosure: Pros DIY is an Amazon Associate. We earn a small commission from qualifying purchases through our affiliate links at no additional cost to you.

Videos produced by Pros DIY (https://www.prosdiy.com) are provided for informational purposes only. Please check with all national, state, provincial, and local codes and regulations before attempting any work. Pros DIY does not assume any responsibility or liability for any damage or injury from the information provided in our videos. Please hire a licensed, certified, professional.